Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPLYMOUTH1993LASER FWD L4-1753CC 1.8L SOHCREPAIR AND DIAGNOSISSTARTING AND CHARGINGSTARTING SYSTEMIGNITION SWITCHSERVICE AND REPAIRIGNITION SWITCH REPLACEMENT
1993 Plymouth Laser FWD L4-1753cc 1.8L SOHC
Ignition Switch Replacement
1993 Plymouth Laser FWD L4-1753cc 1.8L SOHCSECTION Ignition Switch Replacement
Removing Ignition Switch:
Fig. 4 Installing Slide Lever:
Remove ignition switch in numbered sequence, noting the following:
1. With key removed, install slide lever to steering lock cylinder.
2. Connect key interlock cable to slide lever and steering lock cylinder as shown.
3. Apply coating of multi-purpose grease where shown.
4. Remove horn pad attaching screw, then the horn pad by pressing upward.
5. Remove steering wheel using wheel puller.
CAUTION: Do not use hammer as this may damage collapsible mechanism.
6. Reverse procedure to install.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.