Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPLYMOUTH1993LASER FWD L4-1753CC 1.8L SOHCREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSTHROTTLE POSITION SENSORTESTING AND INSPECTIONCOMPONENT TESTS AND GENERAL DIAGNOSTICSSENSOR INSPECTION
1993 Plymouth Laser FWD L4-1753cc 1.8L SOHC
Sensor Inspection
1993 Plymouth Laser FWD L4-1753cc 1.8L SOHCSECTION Sensor Inspection
1. Disconnect the throttle position sensor connector.
2. Measure resistance between terminal (4) (sensor ground) and terminal (1) (sensor power).
Standard value: 3.5k - 6.5k Ohms
3. Connect a pointer type ohmmeter between terminal (4) (sensor ground) and terminal (2) (sensor output).
4. Operate the throttle valve slowly from the idle position to the full open position and check that the resistance changes smoothly in proportion with the throttle valve opening angle.
5. If the resistance is out of specification, or fails to change smoothly. replace the throttle position sensor.
Throttle position sensor installation torque:
1.5-2.5 Nm (1.1 -1.8 ft lb)
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.