SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA RWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 996 (ENGINE CONTROLS - 6.6L (LLY) (INTRODUCTION))REPAIR INSTRUCTIONSAIR INTAKE PIPE REPLACEMENTINSTALLATION PROCEDURE
2004 Oldsmobile Bravada RWD

Installation Procedure

2004 Oldsmobile Bravada RWDSECTION Installation Procedure
WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Turbocharger Air Intake Pipe
    GM1394901Courtesy of GENERAL MOTORS CORP.
  1. Clean the mating surfaces on the air intake pipe (2) and the turbocharger.
  2. Align the air intake pipe (2) to the turbocharger.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
    3. IMPORTANT: The clamp for the air intake pipe uses reverse threads.
  3. Tighten the air intake pipe to turbocharger clamp (1).

    Tighten:  Tighten the clamp to 4.6 N.m (41 lb in).

  4. Install the engine wire harness clamp bolt.

    Tighten:  Tighten the bolt to 10 N.m (89 lb in).

  5. Connect the turbocharger electrical connector.
  6. Install the PCV hose/pipe. Refer to Crankcase Ventilation Hoses/Pipes Replacement in Engine Mechanical - 6.6L (LLY).
  7. Install the air cleaner outlet duct. Refer to Air Cleaner Outlet Duct Replacement .
  8. Install the intake manifold cover. Refer to Intake Manifold Cover Replacement in Engine Mechanical - 6.6L (LLY).
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.