Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA RWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 995 (ENGINE CONTROLS - 6.6L (LB7) (INTRODUCTION))SPECIFICATIONSALTITUDE VS BAROMETRIC PRESSURE
2004 Oldsmobile Bravada RWD
Altitude vs Barometric Pressure
2004 Oldsmobile Bravada RWDSECTION Altitude vs Barometric Pressure
WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
Altitude vs Barometric Pressure
| Altitude Measured in Meters (m) | Altitude Measured in Feet (ft) | Barometric Pressure Measured in Kilopascals (kPa) |
|---|---|---|
| Determine your altitude by contacting a local weather station or by using another reference source. | ||
| 4 267 | 14,000 | 56-64 |
| 3 962 | 13,000 | 58-66 |
| 3 658 | 12,000 | 61-69 |
| 3 353 | 11,000 | 64-72 |
| 3 048 | 10,000 | 66-74 |
| 2 743 | 9,000 | 69-77 |
| 2 438 | 8,000 | 71-79 |
| 2 134 | 7,000 | 74-82 |
| 1 829 | 6,000 | 77-85 |
| 1 524 | 5,000 | 80-88 |
| 1 219 | 4,000 | 83-91 |
| 914 | 3,000 | 87-95 |
| 610 | 2,000 | 90-98 |
| 305 | 1,000 | 94-102 |
| 0 | 0 Sea Level | 96-104 |
| -305 | -1,000 | 101-105 |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.