Power Door Systems Component Views

2004 Oldsmobile Bravada RWDSECTION Power Door Systems Component Views
WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Component Views - Driver Door
GM903357Courtesy of GENERAL MOTORS CORP.
Callout Component Name
1 Driver Door
2 Driver Door Module (DDM)
3 Outside Rearview Mirror - Driver
4 Window Motor - Driver
5 Memory/Heated Seat Switch Connector
6 Door Courtesy Lamp - Left Front
7 Driver Door Panel
8 Memory/Heated Seat Switch
9 Door Latch Assembly - Driver
Fig 2: Component Views - Front Passenger Door
GM903348Courtesy of GENERAL MOTORS CORP.
Callout Component Name
1 Passenger Door Module (PDM)
2 Front Passenger Door
3 Door Latch Assembly - Passenger
4 Heated Seat Switch - Passenger
5 Heated Seat Switch Connector
6 Window Motor - Passenger
7 Outside Rearview Mirror - Passenger
Fig 3: Component Views - Left Rear Side Door
GM1458778Courtesy of GENERAL MOTORS CORP.
Callout Component Name
1 Speaker - LR Door
2 Window Switch Connector - LR
3 C310
4 P700
5 Window Motor - LR
6 Door Latch Assembly Connectors - LR
Fig 4: Component Views - Right Rear Side Door
GM1458783Courtesy of GENERAL MOTORS CORP.
Callout Component Name
1 Window Switch Connector - RR
2 Speaker - RR Door
3 Door Latch Assembly Connectors - RR
4 Window Motor - RR
5 P800
6 C396
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.