Installation Procedure

2004 Oldsmobile Bravada RWDSECTION Installation Procedure
WARNING: This page is about a different car, the 2003 GMC Sonoma, 2003 GMC Jimmy, 2003 Chevrolet S10 Pickup, and 2003 Chevrolet Blazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the headliner to the vehicle. New headliners must be pierced in order to accommodate actual vehicle accessories.
  2. Install the rear upper garnish molding. Refer to GARNISH MOLDING REPLACEMENT - REAR UPPER .
  3. Install the upper body side panel trim. Refer to TRIM PANEL REPLACEMENT - BODY SIDE (STANDARD CAB PICKUP)  or TRIM PANEL REPLACEMENT - BODY SIDE (EXTENDED CAB PICKUP)  or TRIM PANEL REPLACEMENT - BODY SIDE (2-DOOR UTILITY)  or TRIM PANEL REPLACEMENT - BODY SIDE (4-DOOR UTILITY)  or TRIM PANEL REPLACEMENT - BODY SIDE (CREW CAB) .
  4. Install the inside air temperature sensor grille.
    Fig 1: Inside Air Temperature Sensor Grille
    G01478123Courtesy of GENERAL MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.