SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA RWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 957 (SEAT SYSTEM)REPAIR INSTRUCTIONSLUMBAR SWITCH REPLACEMENTINSTALLATION PROCEDURE
2004 Oldsmobile Bravada RWD

Installation Procedure

2004 Oldsmobile Bravada RWDSECTION Installation Procedure
WARNING: This page is about a different car, the 2003 GMC Sonoma, 2003 GMC Jimmy, 2003 Chevrolet S10 Pickup, and 2003 Chevrolet Blazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the switch assembly to the trim panel by snapping the switch into the plastic retaining clips.
    Fig 1: Installing Switch Assembly To Trim Panel By Snapping Switch Into Plastic Retaining Clips
    G01478046Courtesy of GENERAL MOTORS CORP.
  2. Install the electrical connector to the switch.
    Fig 2: Installing Electrical Connector To Switch
    G01478047Courtesy of GENERAL MOTORS CORP.
  3. Install the trim panel to the seat with 3 screws.
  4. Install the seat to the vehicle. Refer to SEAT REPLACEMENT - Bucket  or SEAT REPLACEMENT - Bench .
    Fig 3: Installing Trim Panel To Seat With Screws
    G01478048Courtesy of GENERAL MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.