Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA RWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 931 (POWER STEERING SYSTEM)SPECIFICATIONSFASTENER TIGHTENING SPECIFICATIONS
2004 Oldsmobile Bravada RWD
Fastener Tightening Specifications
2004 Oldsmobile Bravada RWDSECTION Fastener Tightening Specifications
WARNING: This page is about a different car, the 2003 GMC Sonoma, 2003 GMC Jimmy, 2003 Chevrolet S10 Pickup, and 2003 Chevrolet Blazer. However, it is still accessible from the selected car via links, so may be relevant.
Fastener Tightening Specification
| Application | Specification | |||
|---|---|---|---|---|
| Metric | English | |||
| A/C Compressor Mounting Bolts (2.2L) | 50 N.m | 37 lb ft | ||
| A/C Compressor Rear Bracket Mounting Bolts (2.2L) | 31 N.m | 23 lb ft | ||
| Accessory Mounting Bracket Mounting Bolts and Nut | 50 N.m | 37 lb ft | ||
| Coupling Shield Retainer and Lock Nut | 109 N.m | 80 lb ft | ||
| Filler Neck Tube Bolt (4.3L) | 20 N.m | 15 lb ft | ||
| Front Differential Carrier Shield Bolts | 25 N.m | 18 lb ft | ||
| Hood Latch Support Mounting Bolts | 25 N.m | 18 lb ft | ||
| Lower Intermediate Shaft Coupling Bolt | 35 N.m | 26 lb ft | ||
| Pitman Arm Ball Stud to Relay Rod Nut (4WD) | 83 N.m | 61 lb ft | ||
| Pitman Arm Nut | 250 N.m | 184 lb ft | ||
| Pitman Shaft Over-Center Preload(1) | 0.7-1.1 N.m(1) | 6-10 lb in(1) | ||
| Power Steering Cooler Retaining Bolts | 10 N.m | 7 lb ft | ||
| Power Steering Gear Adjuster Lock Nut | 49 N.m | 36 lb ft | ||
| Power Steering Gear Adjuster Nut Assembly | 30 N.m | 22 lb ft | ||
| Power Steering Gear Side Cover Bolts | 60 N.m | 45 lb ft | ||
| Power Steering Gear to Frame Mounting Bolts | 75 N.m | 55 lb ft | ||
| Power Steering Hose Clamps | 2 N.m | 18 lb in | ||
| Power Steering Pressure Hose to Power Steering Gear (2.2L) | 25 N.m | 18 lb ft | ||
| Power Steering Pressure Hose to Power Steering Gear (4.3L) | 30 N.m | 22 lb ft | ||
| Power Steering Pump Flow Control Valve Connector and Fitting Assembly | 75 N.m | 55 lb ft | ||
| Power Steering Pump Front Mounting Bolts (2.2L) | 30 N.m | 22 lb ft | ||
| Power Steering Pump Front Mounting Bolts (4.3L) | 50 N.m | 37 lb ft | ||
| Power Steering Pump Front Mounting Nut (4.3L) | 41 N.m | 31 lb ft | ||
| Power Steering Pump Mounting Studs | 57 N.m | 42 lb ft | ||
| Power Steering Pump Rear Mounting Bracket Bolt (2.2L) | 50 N.m | 37 lb ft | ||
| Power Steering Pump Rear Mounting Bracket Nuts (2.2L) | 50 N.m | 37 lb ft | ||
| Power Steering Pump Rear Mounting Bracket Nut (4.3L) | 41 N.m | 31 lb ft | ||
| Power Steering Return Hose to Power Steering Gear | 25 N.m | 18 lb ft | ||
| Power Steering Return Hose to Power Steering Pump | 25 N.m | 18 lb ft | ||
| Rack Piston Guide Clamp Screw | 6 N.m | 53 lb in | ||
| Rack Piston Plug | 150 N.m | 111 lb in | ||
|
||||
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.