Installation Procedure

2004 Oldsmobile Bravada RWDSECTION Installation Procedure
WARNING: This page is about a different car, the 2003 Pontiac Aztek and 2003 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the sunroof module to the vehicle roof with an assistant.
  2. Install the sunroof module bolts to the sunroof module.

    Tighten 

    Tighten the sunroof module bolts to 10 N.m (89 lb in).

  3. Connect the front and rear drain hoses to the sunroof module.
  4. Connect the electrical connector to the sunroof module assembly.
  5. Inspect for proper operation of the sunroof.
  6. Install the headliner. Refer to HEADLINER REPLACEMENT (AZTEK) or HEADLINER REPLACEMENT (RENDEZVOUS) .
  7. Install the sunroof sunshade. Refer to SUNROOF SUNSHADE PANEL REPLACEMENT  .
    Fig 1: Installing Sunroof Module Assembly
    G01516264Courtesy of GENERAL MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.