Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA RWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 900 (SEAT SYSTEM)REPAIR INSTRUCTIONSMEMORY SEAT CONTROL MODULE REPLACEMENTINSTALLATION PROCEDURE

2004 Oldsmobile Bravada RWD

Installation Procedure

2004 Oldsmobile Bravada RWDSECTION Installation Procedure

WARNING: This page is about a different car, the 2003 Pontiac Aztek and 2003 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.

Install the memory seat module to the seat frame.
Press the module into the bracket until the module is firmly seated.
Connect the electrical connector to the memory seat module.

Fig 1: Installing Memory Seat Module To Seat Frame
Courtesy of GENERAL MOTORS CORP.
Install the seat cushion assembly (1) to the seat riser.
Install the fasteners (2) to the seat cushion assembly (1).

Fig 2: Installing Seat Cushion Assembly To Seat Riser
Courtesy of GENERAL MOTORS CORP.
Adjust the front seat assembly up and forward in order to access the fasteners (1).
Install the fasteners (1) to the seat cushion assembly.
Tighten

Tighten the fasteners to 9 N.m (80 lb in).
Angle the front seat cushion up, in order to access the assembly fasteners.
Tighten

Tighten the fasteners to 9 N.m (80 lb in).
Enable the SIR. Refer to DISABLING & ACTIVATING AIR BAG SYSTEM .

Fig 3: Installing Fasteners To Seat Cushion Assembly
Courtesy of GENERAL MOTORS CORP.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.