SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA RWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 866 (FRONT SUSPENSION SYSTEM)REPAIR INSTRUCTIONSSTABILIZER SHAFT REPLACEMENTINSTALLATION PROCEDURE
2004 Oldsmobile Bravada RWD

Installation Procedure

2004 Oldsmobile Bravada RWDSECTION Installation Procedure
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2003 GMC Yukon XL, 2003 GMC Yukon, 2003 Chevrolet Tahoe, 2003 Chevrolet Suburban, and 2003 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Important:  Place the insulators on the stabilizer shaft with the slits facing toward the front of the vehicle.

  1. Install the insulators (1) to the stabilizer shaft (4).
  2. Install the stabilizer shaft (4).
  3. Install the brackets (2) over the insulators and the stabilizer shaft.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  4. Install insulator bracket bolts (3).

    Tighten 

    1. Tighten the bolts to 33 N.m (24 lb ft), 15 series.
    2. Tighten the bolts to 50 N.m (39 lb ft), 25/35 series.
  5. Install the stabilizer links. Refer to STABILIZER SHAFT LINK REPLACEMENT  .
    Fig 1: Installing Stabilizer Shaft Insulator Bracket & Bolts
    G01455426Courtesy of GENERAL MOTORS CORP.
  6. Install the oil pan skid plate, if equipped.

    Tighten 

    Tighten the oil pan skid plate retaining bolts to 20 N.m (15 lb ft).

  7. Install the tire and wheel assembly. Refer to TIRE AND WHEEL REMOVAL AND INSTALLATION in Tires and Wheels.
  8. Remove the safety stands
  9. Lower the vehicle.
    Fig 2: Installing Oil Pan Skid Plate
    G01455427Courtesy of GENERAL MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.