Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA RWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 857 (SEAT SYSTEM)REPAIR INSTRUCTIONSMEMORY SEAT CONTROL MODULE REPLACEMENTINSTALLATION PROCEDURE

2004 Oldsmobile Bravada RWD

Installation Procedure

2004 Oldsmobile Bravada RWDSECTION Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2003 GMC Yukon XL, 2003 GMC Yukon, 2003 Chevrolet Tahoe, 2003 Chevrolet Suburban, and 2003 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Position the module into the vehicle.
Connect the lower electrical harness connectors (2).

Fig 1: Connecting Lower Electrical Harness Connectors
Courtesy of GENERAL MOTORS CORP.
Slide the module (2) to the left to engage the lower retainers.
NOTE: Refer to Fastener Notice in Cautions and Notices.
Install the module retaining screws (3).
Tighten
1. Tighten the screws to 3 N.m (26 lb in).
Connect the upper electrical harness connectors (3).
Install the seat cushion. Refer to SEAT CUSHION FRAME REPLACEMENT - FRONT .

Fig 2: Installing Module Retaining Screws
Courtesy of GENERAL MOTORS CORP.
If a new memory seat module was installed, the seat needs to synchronized:
1. 7.1. Operate the seat in all directions:
  - Front tilt
  - Rear tilt
  - Horizontal
  - Recline
2. 7.2. If the seat stops part way due to programmed soft stop, release the switch and operate again in the same direction till the seat touches the mechanical stop.
3. 7.3. Repeat the above for all seat positions.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.