SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA RWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 821 (FRONT SUSPENSION SYSTEM)REPAIR INSTRUCTIONSUPPER CONTROL ARM REPLACEMENTINSTALLATION PROCEDURE
2004 Oldsmobile Bravada RWD

Installation Procedure

2004 Oldsmobile Bravada RWDSECTION Installation Procedure
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the upper control arm.
  2. Install the upper control arm bolts (4) for the 25/35 Series 4WD.
    CAUTION: Refer to FASTENER NOTICE .
  3. Install the upper control arm nuts and the adjustment cams (2) 25/35 Series 4WD.

    Tighten 

    Tighten the nuts to 190 N.m (140 lb ft).

    Fig 1: Installing Upper Control Arm (25/35 Series)
    G01662692Courtesy of GENERAL MOTORS CORP.
  4. Install the upper control arm bolts (4) for the 15 Series 2WD, 4WD, and 25/35 Series 2WD.
  5. Install the upper control arm nuts and the adjustment cams (2) for the 15 Series 2WD, 4WD, and 25/35 Series 2WD.

    Tighten 

    Tighten the nuts to 190 N.m (140 lb ft).

    Fig 2: Installing Upper Control Arm (15 Series)
    G01662693Courtesy of GENERAL MOTORS CORP.
  6. Connect the upper control arm to the steering knuckle.
  7. Install the wheel drive shaft. Refer to AXLE SHAFT , AXLE SHAFT or AXLE SHAFT .
  8. Install the new nut to the upper ball joint stud.

    Tighten 

    Tighten the nut to 50 N.m (37 lb ft).

  9. Install the retaining bolts for the brake hose and wheel speed sensor brackets.

    Tighten 

    Tighten the bolts to 9 N.m (80 lb in).

    10. Fig 3: Installing Brake Hose Bracket
    G01662694Courtesy of GENERAL MOTORS CORP.
  10. Connect the RTD link rod to the sensor, if equipped. Refer to FRONT POSITION SENSOR LINK ASSEMBLY REPLACEMENT - ELECTRONIC SUSPENSION .
  11. Install the tire and wheel. Refer to TIRE AND WHEEL REMOVAL AND INSTALLATION .
  12. Remove the safety stands.
  13. Lower the vehicle.
  14. Verify the wheel alignment. Refer to SPECIFICATIONS .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.