SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA RWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 821 (FRONT SUSPENSION SYSTEM)REPAIR INSTRUCTIONSLOWER CONTROL ARM REPLACEMENT (2WD)INSTALLATION PROCEDURE
2004 Oldsmobile Bravada RWD

Installation Procedure

2004 Oldsmobile Bravada RWDSECTION Installation Procedure
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the lower control arm.
  2. Connect the ball joint stud to the steering knuckle.
    CAUTION: Refer to FASTENER NOTICE .
  3. Install the lower ball joint stud nut.

    Tighten 

    Tighten the lower ball joint stud nut to 100 N.m (74 lb ft).

  4. Install the lower control arm bolts for the 15 Series.
  5. Install the lower control arm nuts and the washers for the 15 Series.

    Tighten 

    Tighten the lower control arm nuts to 150 N.m (110 lb ft).

    Fig 1: Installing Lower Control Arm (15 Series)
    G01662698Courtesy of GENERAL MOTORS CORP.
  6. Install the lower control arm bolts for the 25/35 Series.
  7. Install the lower control arm nuts and the washers for the 25/35 Series.

    Tighten 

    Tighten the lower control arm nuts to 150 N.m (110 lb ft).

    8. Fig 2: Installing Lower Control Arm (25/35 Series)
    G01662699Courtesy of GENERAL MOTORS CORP.
  8. Install the torsion bar. Refer to Torsion Bar Replacement .
  9. Install the front stabilizer shaft link. Refer to Stabilizer Shaft Replacement .
  10. Install the shock absorber. Refer to Shock Absorber Replacement (2WD)  or Shock Absorber Replacement (4WD)  .
  11. Install the tire and wheel. Refer to TIRE AND WHEEL REMOVAL AND INSTALLATION .
  12. Remove the safety stands.
  13. Lower the vehicle.
  14. Verify the wheel alignment. Refer to SPECIFICATIONS .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.