Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA RWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 795 (HVAC SYSTEM)CONTROL SYSTEMCLIMATE CONTROL UNIT WIRE ADJUSTMENTAIRFLOW MODE WIRE
2004 Oldsmobile Bravada RWD
Airflow Mode Wire
2004 Oldsmobile Bravada RWDSECTION Airflow Mode Wire
WARNING: This page is about a different car, the 2004 Mazda 3. However, it is still accessible from the selected car via links, so may be relevant.
- Set the airflow mode selector dial at defroster.CAUTION:
- If the airflow mode wire is set without first fixing the airflow mode main link position, it is possible that the airflow mode door cannot be switched normally.
- Set the airflow mode main link to the vent position and insert an approx. No. 5 Phillips screwdriver into the set hole to fix the position of the link.
- Connect the airflow mode wire to airflow mode main link.
- Clamp the airflow mode wire to wire clamp.
- Remove the screwdriver and verify that the airflow mode selector dial can move its full stroke.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.