SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA RWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 795 (HVAC SYSTEM)CONTROL SYSTEMBLOWER MOTOR INSTALLATIONNOTES
2004 Oldsmobile Bravada RWD

Blower Motor Installation: Notes

2004 Oldsmobile Bravada RWDSECTION Notes
WARNING: This page is about a different car, the 2004 Mazda 3. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the SST  to the blower motor. See SST Installation Note .
  2. Install the blower motor with the SST (49 B061 015)  installed, to the A/C unit. See BLOWER MOTOR INSTALLATION NOTE .
  3. Install the blower motor cover from the driver's side. See BLOWER MOTOR COVER INSTALLATION NOTE .
  4. Remove the SST (49 B061 015)  from the blower motor.
  5. Connect the blower motor connector as shown in the figure.
    Fig 1: Connecting Blower Motor Connector
    G00975585Courtesy of MAZDA MOTORS CORP.
  6. Install the blower motor cooling pipe.
    Fig 2: Installing Blower Motor Cooling Pipe
    G00975586Courtesy of MAZDA MOTORS CORP.
  7. Install the air guide.
  8. Connect the resistor connector.
  9. Install the lower panel. See LOWER PANEL REMOVAL/INSTALLATION .
  10. Install the front side trim. See FRONT SIDE TRIM REMOVAL/INSTALLATION .
  11. Install the front scuff plate. See FRONT SCUFF PLATE REMOVAL/INSTALLATION .
  12. Install the hood release lever from the lower panel. See HOOD LATCH AND RELEASE LEVER REMOVAL/INSTALLATION .
  13. Install the blower case with the intake door at FRESH. See BLOWER CASE INSTALLATION NOTE .
  14. Connect the air intake actuator connector.
  15. Install the following parts:
    1. Auto leveling control module. See AUTO LEVELING SENSOR REMOVAL/INSTALLATION .
    2. Car-navigation unit. See CAR-NAVIGATION SYSTEM .
    3. PJB and PJB bracket. See FUSES & CIRCUIT BREAKERS .
    4. Glove compartment. See GLOVE COMPARTMENT REMOVAL/INSTALLATION .
    5. Decoration panel. See DECORATION PANEL REMOVAL/INSTALLATION .
    6. Front scuff plate (RH). See FRONT SCUFF PLATE REMOVAL/INSTALLATION .
    7. Front side trim (RH). See FRONT SIDE TRIM REMOVAL/INSTALLATION .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.