SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA RWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 795 (HVAC SYSTEM)BASIC SYSTEMAIRFLOW MODE MAIN LINK REMOVAL/INSTALLATIONNOTES
2004 Oldsmobile Bravada RWD

Airflow Mode Main Link Removal/Installation: Notes

2004 Oldsmobile Bravada RWDSECTION Notes
WARNING: This page is about a different car, the 2004 Mazda 3. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the negative battery cable.
  2. Detach the hood release lever from the lower panel. See HOOD LATCH AND RELEASE LEVER REMOVAL/INSTALLATION .
  3. Remove the front scuff plate. See FRONT SCUFF PLATE REMOVAL/INSTALLATION .
  4. Remove the front side trim. See FRONT SIDE TRIM REMOVAL/INSTALLATION .
  5. Remove the lower panel. See LOWER PANEL REMOVAL/INSTALLATION .
  6. Remove the shower duct (LH).
  7. Disconnect the airflow mode wire. See CLIMATE CONTROL UNIT REMOVAL .
  8. Remove the airflow mode rod (1).
  9. Remove the airflow mode main link.
    Fig 1: Removing Airflow Mode Main Link
    G00975551Courtesy of MAZDA MOTORS CORP.
  10. Install in the reverse order of removal.
  11. Adjust the airflow mode wire. See CLIMATE CONTROL UNIT WIRE ADJUSTMENT .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.