Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Locknut (on Adjusting Cover) Assembly Note
2004 Oldsmobile Bravada RWDSECTION Locknut (on Adjusting Cover) Assembly Note
WARNING: This page is about a different car, the 2004 Mazda 3. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
- Be sure that the adjusting cover will not turn together with the locknut.
- Fix the adjusting cover and tighten the locknut.
- Measure the pinion torque using the torque wrench.
- Standard Center of rack+/-90° 0.88-1.48 N.m {8.98-15.0 kgf.cm, 7.79-13.0 in.lbf}
- If not as specified, remove the locknut and adjust the adjust cover.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.