Installation Procedure

2004 Oldsmobile Bravada RWDSECTION Installation Procedure
WARNING: This page is about a different car, the 2002 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the front fender liner to the front fender.
  2. Install the push-in retainers to the front fender liner.
    CAUTION: Refer to FASTENER NOTICE .
  3. Install the front fender liner to front fender bolts (4).

    Tighten 

    Tighten the bolts to 2 N.m (18 lb in).

    Fig 1: Installing Front Fender Liner
    G01780178Courtesy of GENERAL MOTORS CORP.
  4. Install the front fender liner to front bumper fascia bolts.

    Tighten 

    Tighten the bolts to 2 N.m (18 lb in).

  5. Fig 2: Installing Front Fender Liner To Front Bumper Fascia Bolts
    G01780179Courtesy of GENERAL MOTORS CORP.
  6. Position the mud flap to the front fender, if equipped.
  7. Install the front mud flap screws.

    Tighten 

    Tighten the screws to 2 N.m (18 lb in).

  8. Install the tire and wheel assembly. Refer to TIRE AND WHEEL REMOVAL AND INSTALLATION .
  9. Lower the vehicle.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.