SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA RWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 765 (BATTERY)REPAIR INSTRUCTIONSBATTERY REPLACEMENTINSTALLATION PROCEDURE
2004 Oldsmobile Bravada RWD

Installation Procedure

2004 Oldsmobile Bravada RWDSECTION Installation Procedure
WARNING: This page is about a different car, the 2002 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.

Important:  Do not tip the battery more than 40 degrees during battery installation.

  1. Install the battery to the battery tray.
    CAUTION: Refer to FASTENER NOTICE in Cautions and Notices.
  2. Install the battery hold down retainer.

    Tighten 

    Tighten bolt to 18 N.m (13 lb ft).

    Fig 1: Installing Battery
    G01811440Courtesy of GENERAL MOTORS CORP.
  3. Connect the positive battery cable.

    Tighten 

    Tighten the positive battery cable bolt (1 ) to 15 N.m (11 lb ft).

  4. Connect the negative battery cable (2 ). Refer to Battery Negative Cable Disconnect/Connect Procedure  .
    Fig 2: Connecting Battery Cables
    G01811441Courtesy of GENERAL MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.