Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Removal Procedure
- Remove the left front fender liner. Refer to FRONT FENDER LINER REPLACEMENT .
- Disconnect the washer solvent container level sensor electrical connector.
Courtesy of GENERAL MOTORS CORP.
Important: The washer solvent will drain from the washer solvent container when the washer solvent container level sensor is removed. Place a suitable drain pan under the container before removing the washer solvent container level sensor.
- Using a small flat-bladed tool, remove the washer solvent container level sensor from the washer solvent container.
- Using a small flat-bladed tool, remove the seal from the washer solvent container.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.