Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Installation Procedure
2004 Oldsmobile Bravada RWDSECTION Installation Procedure
WARNING: This page is about a different car, the 2002 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
- Clean the EBCM gasket and the BPMV surface with alcohol using a clean rag.
- Install the EBCM (1) to the BPMV (2).CAUTION: Refer to FASTENER NOTICE in Cautions and Notices.
- Install the 4 screws that attach the EBCM (1) to the BPMV (2).
Tighten
Tighten the screws to 5 N.m (44 lb in).
- Connect the EBCM harness connector (2) to the EBCM (1).
- Push down the harness connector lock tab (1) and then move the sliding connector cover back in the home position to lock.
- Push the CPA (2) back into place.
- Install the left engine splash shield.
- Lower the vehicle. Refer to LIFTING AND JACKING THE VEHICLE in General Information.
- Perform the Diagnostic System Check - ABS .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.