Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA RWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 746 (BATTERY)SPECIFICATIONSFASTENER TIGHTENING SPECIFICATIONS
2004 Oldsmobile Bravada RWD
Fastener Tightening Specifications
2004 Oldsmobile Bravada RWDSECTION Fastener Tightening Specifications
WARNING: This page is about a different car, the 2002 GMC Savana Special, 2002 GMC Savana Camper Special, 2002 GMC Savana, and 2002 Chevrolet Chevy Express. However, it is still accessible from the selected car via links, so may be relevant.
Fastener Tightening Specifications
| Application | Specification | |
|---|---|---|
| Metric | English | |
| Auxiliary Battery Hold Down Retaining Bolt | 25 N.m | 18 lb ft |
| Auxiliary Battery Tray Retaining Bolts | 25 N.m | 18 lb ft |
| Auxiliary Generator Brace Mounting (Long) Bolts | 50 N.m | 37 lb ft |
| Auxiliary Generator Brace Mounting (Short) Bolts | 25 N.m | 18 lb ft |
| Auxiliary Positive and Negative Battery Cable Retaining Bolts to the Battery | 15 N.m | 11 lb ft |
| Battery Negative Cable Lead to Engine Block Bolt | 25 N.m | 18 lb ft |
| Battery Negative Cable Lead to Inner Fender Well Bolt | 10 N.m | 89 lb in |
| Battery Negative/ Positive Terminal Bolts | 17 N.m | 13 lb ft |
| Front Battery Hold Down Retaining Bolt | 25 N.m | 18 lb ft |
| Front Battery Tray Retaining Bolts | 25 N.m | 18 lb ft |
| Generator Brace to the Generator Bracket Retaining Bolts (4.3L, 5.0L and 5.7L) | 50 N.m | 37 lb ft |
| Generator Bracket Mounting Bolts and Nuts (4.3L, 5.0L and 5.7L) | 41 N.m | 30 lb ft |
| Generator Bracket Mounting Bolts and Nuts (8.1 L) | 50 N.m | 37 lb ft |
| Generator Bracket Mounting Bolts and Nuts (6.5L Diesel) | 50 N.m | 37 lb ft |
| Generator Front Mounting Bolts (6.5L) | 50 N.m | 37 lb ft |
| Generator Output (Bat) Terminal Nut | 18 N.m | 13 lb ft |
| Generator Pulley Retaining Nut | 75 N.m | 55 lb ft |
| Generator Rear Mounting Bolts (6.5L) | 25 N.m | 18 lb ft |
| Ignition Wire Harness to the Starter Motor Solenoid (Diesel Engines) | 6 N.m | 53 lb in |
| Ignition Wire Harness to the Starter Motor Solenoid (Gas Engines) | 2 N.m | 18 lb in |
| Oil Fill Tube Screws | 5 N.m | 44 lb in |
| Oil Fill Tube Support Bracket Bolt | 25 N.m | 18 lb ft |
| Positive Battery Cable Lead to Junction Block Retaining Nut | 10 N.m | 89 lb in |
| Positive Battery Cable to the Starter Motor Solenoid (Diesel Engines) | 16 N.m | 12 lb ft |
| Positive Battery Cable to the Starter Motor Solenoid (Gas Engines) | 10 N.m | 89 lb in |
| Starter Motor Bracket Bolt to the Engine (Diesel Engines) | 17 N.m | 13 lb ft |
| Starter Motor Field Lead Retaining Nut | 11 N.m | 97 lb in |
| Starter Motor Heat Shield Retaining Bolts | 3 N.m | 27 lb in |
| Starter Motor Heat Shield Retaining Nuts | 6 N.m | 53 lb in |
| Starter Motor Retaining Bolts to the Engine | 45 N.m | 33 lb ft |
| Starter Motor Retaining Nut to the Engine Bracket (Diesel Engines) | 10 N.m | 89 lb in |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.