Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA RWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 739 (BODY FRONT END)REPAIR INSTRUCTIONSHOOD LATCH RELEASE CABLE REPLACEMENTINSTALLATION PROCEDURE

2004 Oldsmobile Bravada RWD

Installation Procedure

2004 Oldsmobile Bravada RWDSECTION Installation Procedure

WARNING: This page is about a different car, the 2002 GMC Savana Special, 2002 GMC Savana Camper Special, 2002 GMC Savana, and 2002 Chevrolet Chevy Express. However, it is still accessible from the selected car via links, so may be relevant.

Position the cable (1) to the vehicle.

Fig 1: Installing Cable
Courtesy of GENERAL MOTORS CORP.
Route the cable (1) from the cabin into the engine compartment.
Install the cable grommet into the front of dash.
Install the cable handle (3) to the hinge pillar.
Install the screws to the hood release handle (3) to the pillar.
Install the left side hinge pillar trim panel to the body. Refer to TRIM REPLACEMENT - HINGE PILLAR .
Install the cable (1) to the retainer on the radiator support.
Install the cable (1) to the hood latch.
Close the hood.
Inspect the hood release cable for proper operation.

Fig 2: Installing Cable Handle
Courtesy of GENERAL MOTORS CORP.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.