Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA RWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 739 (BODY FRONT END)REPAIR INSTRUCTIONSFENDER REPLACEMENT - FRONTREMOVAL PROCEDURE

2004 Oldsmobile Bravada RWD

Removal Procedure

2004 Oldsmobile Bravada RWDSECTION Removal Procedure

WARNING: This page is about a different car, the 2002 GMC Savana Special, 2002 GMC Savana Camper Special, 2002 GMC Savana, and 2002 Chevrolet Chevy Express. However, it is still accessible from the selected car via links, so may be relevant.

Remove the right and the left air inlet grille panels from the vehicle. Refer to Air Inlet Grille Panel Replacement .
Remove the hood from the vehicle. Refer to Hood Replacement .
Remove the upper fender filler panel from the vehicle. Refer to Filler Panel Applique Replace - Upper Front Fender .
Remove the front fender extension from the vehicle. Refer to Fender Extension Replacement - Front .
Remove the front bumper from the vehicle. Refer to BUMPER REPLACEMENT - FRONT .
Drill out the rivets (1) retaining the front fender (2) to the front door hinges.
Remove the bolts (3) retaining the front fender (2) to the body.
Remove the hood rod support from the left fender. Refer to Hood Hold-Open Rod Replacement .
Remove the front fender (2) from the vehicle.

Fig 1: Removing Front Fender
Courtesy of GENERAL MOTORS CORP.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.