Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Installation Procedure
2004 Oldsmobile Bravada RWDSECTION Installation Procedure
WARNING: This page is about a different car, the 2002 GMC Sierra, 2002 GMC Cab & Chassis Sierra, 2002 Chevrolet Silverado, and 2002 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
- Slide the module in until seated.
- Install the memory module retaining screws (1). Tighten the screws to 3 N.m (26 lb in).
- Connect the harness connectors (2).
- Install the seat cushion. Refer to Seat Cushion Frame Replacement - Front .
- Install the seat trim panel. Refer to Trim Panel Replacement - Front Seat .
- If a new memory seat module is installed, the seat needs to be synchronized:
- 6.1. Operate the seat in all directions:
- Front tilt
- Rear tilt
- Horizontal
- Recline
- 6.2. If the seat stops part way due to programmed soft stop, release the switch and operate again in the same direction till the seat touches the mechanical stop
- 6.3. Repeat the above for all seat moving axes.
- 6.1. Operate the seat in all directions:
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.