Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Installation Procedure
2004 Oldsmobile Bravada RWDSECTION Installation Procedure
WARNING: This page is about a different car, the 2002 GMC Sierra, 2002 GMC Cab & Chassis Sierra, 2002 Chevrolet Silverado, and 2002 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
- Install the wiper motor onto the wiper transmission assembly with the 2 bolts. Tighten the 2 bolts to 8 N.m (71 lb in).
- Install the drive link onto the wiper motor crank arm with the J 39529 .
- Install the wiper transmission assembly on the vehicle with the 2 bolts. Tighten the 2 bolts to 9 N.m (80 lb in).
- Connect the electrical connector to the wiper motor.
- Install the reinforcement panel with the 4 bolts. Tighten the 4 bolts to 9 N.m (80 lb in).
- Install the air inlet grille panel.
- Install the wiper arms. Refer to Wiper Arm Replacement .
- Operate the wipers and check for proper operation.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.