Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA RWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 670 (POWER SEAT SYSTEM)SPECIFICATIONS
2004 Oldsmobile Bravada RWD
Section 670 (Power Seat System): Specifications
2004 Oldsmobile Bravada RWDSECTION Specifications
WARNING: This page is about a different car, the 2002 Oldsmobile Aurora and 2001 Oldsmobile Aurora. However, it is still accessible from the selected car via links, so may be relevant.
Fastener Tightening Specifications
| Application | Specification | |
|---|---|---|
| Metric | English | |
| Front Seat Adjuster Reinforcement Bracket Fasteners | 9 N.m | 80 lb in |
| Front Seat Adjuster Track Cover Fasteners | 2 N.m | 18 lb in |
| Front Seat Adjuster Track Reinforcement Bracket Fasteners | 50 N.m | 37 lb ft |
| Front Seat Anchor Fasteners | 30 N.m | 22 lb ft |
| Front Seat Back Frame Fasteners | 28 N.m | 21 lb ft |
| Front Seat Back Recliner Fasteners | 50 N.m | 37 lb ft |
| Front Seat Back Recliner Handle Fasteners | 2 N.m | 18 lb in |
| Front Seat Cushion Fasteners | 9 N.m | 80 lb in |
| Heated Seat Module Fasteners | 2 N.m | 18 lb in |
| Memory Seat Module Fasteners | 2 N.m | 18 lb in |
| Rear Seat Armrest Fasteners | 5 N.m | 44 lb in |
| Rear Seatback Fasteners | 41 N.m | 30 lb ft |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.