Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Installation Procedure
2004 Oldsmobile Bravada RWDSECTION Installation Procedure
WARNING: This page is about a different car, the 2002 Oldsmobile Aurora and 2001 Oldsmobile Aurora. However, it is still accessible from the selected car via links, so may be relevant.
- Install the power recliner position sensor (5) to the motor (4).
- Slide the recliner rod through the power recliner position sensor (5) the seat back recliner motor (4), and the recliner assembly.
- Install a new push on nut (6) to the end of the recliner rod (2).
- Connect the electrical connector to the power recliner position sensor (5).
- Install the seat back cover and pad. Refer to Seat Back Cover And Pad Replacement - Front .
- Install the front seat. Refer to Seat Replacement - Bucket
- Enable the SIR system. Refer to ACTIVATING SYSTEM in SIR.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.