Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA RWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 670 (POWER SEAT SYSTEM)REPAIR INSTRUCTIONSMEMORY SEAT SWITCH REPLACEMENTREMOVAL PROCEDURE
2004 Oldsmobile Bravada RWD
Removal Procedure
2004 Oldsmobile Bravada RWDSECTION Removal Procedure
WARNING: This page is about a different car, the 2002 Oldsmobile Aurora and 2001 Oldsmobile Aurora. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the inside handle bezel from the door trim pad. Refer to HANDLE BEZEL REPLACEMENT -- INSIDE in Doors.
- Remove the front door switch plate. Refer to FRONT DOOR SWITCH REPLACEMENT in Doors.
- Disconnect the electrical connector for the memory seat switch through the power door switch opening in the door trim panel.
- Remove the memory seat switch from the inside handle bezel by releasing the tabs with a small flat bladed tool.
- Gently remove the electrical wiring for the memory seat switch from behind the door trim panel.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.