Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Test Description
2004 Oldsmobile Bravada RWDSECTION Test Description
WARNING: This page is about a different car, the 2002 Oldsmobile Aurora and 2001 Oldsmobile Aurora. However, it is still accessible from the selected car via links, so may be relevant.
The number(s) below refer to the step number(s) on the diagnostic table.
- 3.This step verifies that the personalization option is active.
- 4. Turning ON the headlamps switch in this step eliminates the possibility of the memory function switch finding an alternative path to ground through the illumination circuit.
- 7. If the fuse in the jumper wire opens when you perform this test, the signal circuit is shorted to battery voltage.
- 9. If the fuse in the jumper wire opens when you perform this test, the signal circuit is shorted to battery voltage.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.