SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA RWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 649 (ELECTRONIC SUSPENSION SYSTEM - AUTOMATIC LEVEL CONTROL)REPAIR INSTRUCTIONSAIR COMPRESSOR REPLACEMENTREMOVAL PROCEDURE
2004 Oldsmobile Bravada RWD

Removal Procedure

2004 Oldsmobile Bravada RWDSECTION Removal Procedure
WARNING: This page is about a different car, the 2002 Oldsmobile Aurora. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise the vehicle.
  2. Remove the right rear wheel. Refer to TIRE AND WHEEL REMOVAL AND INSTALLATION .
  3. Remove the right rear fascia extension. Refer to FASCIA EXTENSION REPLACEMENT -- REAR in Bumpers.

    Important:  Before disconnecting the air hose from the intake air filter or the air compressor, clean the components and the surrounding area to prevent dirt and other foreign material from entering the ELC system.

  4. Disconnect the air tube from the air dryer.
  5. Remove the bolt and the harness tie with the air tube from the air compressor bracket.
    6. Fig 1: Removing Harness Tie & Bolt
    G01582148Courtesy of GENERAL MOTORS CORP.
  6. Remove the intake air filter from the vehicle.
  7. Disconnect the air compressor connector.
  8. Remove the 2 nuts, the bolt, and the air compressor from the vehicle.
    Fig 2: Removing Air Compressor
    G01582149Courtesy of GENERAL MOTORS CORP.
  9. Slide the air compressor connector off of the connector anchor.
  10. Remove 2 bolts and the heat shield from the air compressor bracket.
    Fig 3: Removing Heat Shield & Bolts
    G01582150Courtesy of GENERAL MOTORS CORP.
  11. Remove 3 bolts and the air compressor from the bracket.
  12. Remove the air dryer from the air compressor. Refer to Automatic Level Control Air Dryer Replacement .
    Fig 4: Removing Air Compressor From Bracket
    G01582151Courtesy of GENERAL MOTORS CORP.
  13. Disconnect the air hose from the air compressor.
    Fig 5: Disconnecting Air Hose From Air Compressor
    G01582152Courtesy of GENERAL MOTORS CORP.
  14. Remove the 2 screws and the 2 brackets from the air compressor.
    Fig 6: Removing Bracket & Screws From Air Compressor
    G01582153Courtesy of GENERAL MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.