Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Removal Procedure
2004 Oldsmobile Bravada RWDSECTION Removal Procedure
WARNING: This page is about a different car, the 2002 GMC Savana Special, 2002 GMC Savana Camper Special, 2002 GMC Savana, and 2002 Chevrolet Chevy Express. However, it is still accessible from the selected car via links, so may be relevant.
Important: After installation, calibrate the new EBCM to the tire size that is appropriate to the vehicle.
- Raise vehicle and properly support.
- Remove the three EHCU (1) shield bolts and shield.
- Disconnect the four electrical connectors from EBCM.
- Remove the three bolts (1) that fasten the EHCU bracket to the frame.
- Remove the EHCU from the frame allowing enough clearance to access the EBCM. Be careful not to bend the brake pipes attached to the EHCU.
- Remove the four T-25 Torx® bolts (1) that fasten the EBCM to the BPMV.
Remove the EBCM (2) from the BPMV (4).
Removal may require a light amount of force.
CAUTION: Do not use a tool to pry the EBCM or the BPMV. Excessive force will damage the EBCM. - Clean the BPMV with a clean, dry cloth.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.