Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Disassembly Procedure
2004 Oldsmobile Bravada RWDSECTION Disassembly Procedure
WARNING: This page is about a different car, the 2002 Buick Regal and 2002 Buick Century. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the strut from the vehicle. Refer to Strut Assembly Replacement .
- Install the strut (1) in the J 34013-B using adapters J 34013-971, J-34013-972 and the J 3289-20 .
- Turn the compressor forcing screw (3) until the spring compresses slightly.
- Use a 45 TORX® socket in order to hold the strut shaft. Remove the strut mount nut by turning with J 42991 .
- Install the J 34013-197 to help guide the strut shaft out of the strut upper mount.
- Loosen the compressor screw while guiding the strut shaft out of the strut upper mount. Continue loosening the compressor forcing screw until you can remove the strut and the spring.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.