Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA RWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 604 (REAR SUSPENSION SYSTEM)REPAIR INSTRUCTIONSSUPPORT REPLACEMENTREMOVAL PROCEDURE
2004 Oldsmobile Bravada RWD
Removal Procedure
2004 Oldsmobile Bravada RWDSECTION Removal Procedure
WARNING: This page is about a different car, the 2002 Buick Regal and 2002 Buick Century. However, it is still accessible from the selected car via links, so may be relevant.
- Raise and support the vehicle.
- Remove the rear tires and wheels.
- Remove the exhaust pipe.
- Disconnect the brake lines from the rear suspension support.
- Disconnect the parking brake cables and tensioner from the suspension support. Refer to appropriate PARK BRAKE CABLE .
- Remove the stabilizer shaft from the rear suspension support. Refer to STABILIZER SHAFT REPLACEMENT .
NOTE:
Support the rear suspension support with jack stands before removing the mounting bolts.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.