Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Coolant Level
The engine coolant level can be checked at engine coolant surge tank. The coolant level should be checked when system is cool and not under pressure. The coolant level should be within the cold fill range which is between the surge tank seam and mark 1" (molded in tank with arrow) below seam. If coolant level is low, check for system leaks, and then slowly open coolant surge tank cap. Add coolant until level reaches the cold line (surge tank seam).
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.