Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Rear Coil Spring Installation Note
2004 Oldsmobile Bravada RWDSECTION Rear Coil Spring Installation Note
WARNING: This page is about a different car, the 2004 Mazda 3. However, it is still accessible from the selected car via links, so may be relevant.
- Position the jack under the rear lower arm and jack up slowly.
- Align the upper end of the rear coil spring with the step of the upper spring seat rubber.
- Align the lower end of the rear coil spring with the step of the lower spring seat rubber.
- Install the lower arm outer bolt.
WARNING:
Installing the coil spring is dangerous. The coil spring could fly off and cause serious injure or death, and damage the vehicle.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.