Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA RWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 505 (ELECTRICAL COMPONENT LOCATOR)CONNECTORS
2004 Oldsmobile Bravada RWD
Section 505 (Electrical Component Locator): Connectors
2004 Oldsmobile Bravada RWDSECTION Connectors
WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
CONNECTORS LOCATION
| Component | Location |
|---|---|
| C100 (Black, 8 Pin) | At right skid bar, in front of horn. See Figure . |
| C102 (Black, 16 Pin) | At right rear of engine compartment. See Figure . |
| C105 (Gray, 2 Pin) | On engine, above left lower control arm. |
| C107 | Left front corner of engine compartment. See Figure . |
| C108 (Gray, 2 Pin) | On engine, above right lower control arm. |
| C109 (Gray, 8 Pin) | At top center of left valve cover. See Figure . |
| C110 (Gray, 8 Pin) | At top center of right valve cover. See Figure . |
| C112 (Black, 2 Pin) | At top rear of engine, mounted to vacuum hose. See Figure . |
| C113 (Black, 2 Pin) | At right side of lower radiator support. See Figure . |
| C140 (Black, 10 Pin) | At right side of engine compartment, below battery. See Figure . |
| C142 (Gray, 20 Pin) | At right rear of engine compartment, below battery. |
| C144 (Gray, 20 Pin) | At right rear of engine compartment, below battery. |
| C146 (Black, 10 Pin) | At right rear of engine compartment, below battery. |
| C148 (Black, 10 Pin) | At right rear of engine compartment, below battery. See Figure . |
| C150 (Gray, 20 Pin) | At right rear of engine compartment, below battery. See Figure . |
| C152 (Black, 3 Pin) | At left side of engine compartment, on left wheelwell. |
| C200 (Black, 6 Pin) | In grommet, on right door. See Figure . |
| C201 (Black, 6 Pin) | In grommet, on left door. See Figure . |
| C202 (Blue, 10 Pin) | In grommet, on right door. See Figure . |
| C203 (Blue, 10 Pin) | In grommet, on left door. See Figure . |
| C204 (Black, 4 Pin) | At right of instrument panel fuse block, mounted to toe board, behind carpet. See Figure . |
| C206 (Black, 3 Pin) | Above body control module, taped to harness. |
| C207 (Black, 4 Pin) | On lower dash bar, for steering column lock. See Figure . |
| C208 (Black, 3 Pin) | At left side of steering column, on dash lower beam. |
| C209 (Black, 23 Pin) | On lower dash bar-headlight & turn signal switches. See Figure . |
| C210 (Black, 2 Pin) | At left side of steering column, on lower dash beam. See Figure . |
| C211 (Yellow, 2 Pin) | At left side of steering column, on lower dash bar. See Figure . |
| C212 (Black, 3 Pin) | At left side of steering column, on lower dash beam. |
| C213 (Yellow, 2 Pin) | Taped to dash harness, near BOSE signal processor. See Figure . |
| C215 (Natural, 10 Pin) | Behind hazard warning switch. |
| C217 (Black, 4 Pin) | At left side of steering column, on lower dash bar. See Figure . |
| C219 (Black, 6 Pin) | At left side of steering column, on lower dash beam. See Figure . |
| C220 (Black, 8 Pin) | Between dash harness & vanity mirror jumper. |
| C301 (Black, 6 Pin) | Under left seat. See Figure . |
| C302 (Black, 6 Pin) | Under right seat. See Figure . |
| C303 (Blue, 8 Pin) | Under left seat. |
| C400 (Black, 8 Pin) | At rear of right control arm. |
| C402 (Black, 10 Pin) | Between transmission harness & fuel tank jumper harness. See Figure . |
| C403 (Black, 2 Pin) | On frame, below left shock absorber. |
| C406 (Black, 2 Pin) | On frame, below right shock absorber. |
| C410 (1 Pin) | Front body harness to antenna/defogger jumper harness. |
| C412 (Black, 4 Pin) | Between left & right fuel tanks. See Figure . |
| C414 (Black, 6 Pin) | Between left & right fuel tanks. See Figure . |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.