Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA RWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 484 (COMMON SPECS & PROCEDURES)BATTERYGENERAL SERVICEBATTERY TORQUE SPECIFICATIONS
2004 Oldsmobile Bravada RWD
Battery Torque Specifications
2004 Oldsmobile Bravada RWDSECTION Battery Torque Specifications
WARNING: This page is about a different car, the 2003 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.
BATTERY TORQUE SPECIFICATIONS
| Application | Ft. Lbs. (N.m) |
|---|---|
| Battery Cables-To-Battery Bolt | 13 (17) |
| Battery Hold Down Bolt | 13.3 (18) |
| Battery Negative Cable-To-Engine Block Bolt | 37 (50) |
| Battery Negative Cable-To-Side Rail Bolt | 27 (36) |
| Battery Negative Terminal Bolt | 11 (15) |
| Battery Positive Cable-To-Underhood Fuse Block Nut | 11 (15) |
| Battery Positive Terminal Bolt | 11 (15) |
| Battery Retainer Bolt | 18 (25) |
| Battery Side Terminal Adapter | 11 (15) |
| Generator Bolt | 37 (50) |
| Generator Brace Bolt | 22 (30) |
| Generator Mounting Bolt | 26 (35) |
| Generator Output BAT Terminal Nut | 15 (20) |
| Generator Rear Brace Bolt/Nut | 37 (50) |
| Generator Rear Bracket Bolt | 37 (50) |
| Generator Stud | 37 (50) |
| Starter Bolt | 32 (43) |
| Starter Motor Mounting Bolt | 30 (40) |
| Transaxle Stud Nut | 22 (30) |
| INCH Lbs. (N.m) | |
| Battery Positive Cable Junction Block Lead Nut | 89 (10) |
| Battery Positive Cable-To-Starter Terminal Nut | 111 (12.5) |
| Battery Tray Bolt | 44 (5) |
| Front Air Inlet Panel Assembly Bolt | 53 (6) |
| Ground Wire Bolt | 89 (10) |
| Starter Heat Shield Fastener | 71 (8) |
| Starter Heat Shield Mounting Bracket Nut | 71 (8) |
| Starter Solenoid BAT Terminal Nut | 89 (10) |
| Starter Solenoid "S" Terminal Nut | 27 (3) |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.