Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA RWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 469 (ENGINE CONTROLS - REMOVAL & INSTALLATION)FUEL SYSTEMSFUEL PRESSURE REGULATORINSTALLATION
2004 Oldsmobile Bravada RWD
Fuel Pressure Regulator: Installation
2004 Oldsmobile Bravada RWDSECTION Installation
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2003 GMC Yukon XL, 2003 GMC Yukon, 2003 Chevrolet Tahoe, 2003 Chevrolet Suburban, and 2003 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
- Install back-up ring, "O" ring, fuel pressure regulator filter and remaining "O" ring onto the fuel pressure regulator. Lubricate the fuel pressure regulator "O" rings with clean engine oil. Install the fuel pressure regulator.
- Install NEW fuel pressure regulator retainer. Connect fuel pressure regulator vacuum line. To complete installation, reverse removal procedure.
- Turn ignition switch to ON position for 2 seconds. Turn ignition switch to OFF position for 10 seconds. Turn ignition switch to ON position. Check for fuel leaks. Repair as necessary. Tighten intake manifold sight shield bolt and intake manifold sight shield retainer bolts to specification. See TORQUE SPECIFICATIONS .
- Install back-up ring onto fuel pressure regulator, followed by the large "O" ring, fuel pressure regulator filter and small "O" ring. See Figure. Lubricate large and small fuel pressure regulator "O" rings with clean engine oil.
- Push fuel pressure regulator into fuel pressure regulator housing on fuel rail. Install a NEW fuel pressure regulator retainer. Connect fuel pressure regulator vacuum line. To complete installation, reverse removal procedure.
- Turn ignition switch to ON position for 2 seconds. Turn ignition switch to OFF position for 10 seconds. Turn ignition switch to ON position. Check for fuel leaks. Repair as necessary. Tighten intake manifold sight shield retaining bolt to specification. See TORQUE SPECIFICATIONS .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.