Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA RWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 444 (ENGINE CONTROLS - SELF-DIAGNOSTICS)DIAGNOSTIC TESTSDTC P0106: MAP SYSTEM PERFORMANCENOTES
2004 Oldsmobile Bravada RWD
DTC P0106: Map System Performance: Notes
2004 Oldsmobile Bravada RWDSECTION Notes
WARNING: This page is about a different car, the 2003 Oldsmobile Aurora. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
To locate components, see COMPONENT LOCATIONS . For circuit reference, see WIRING DIAGRAMS . For connector terminal identification, see CONNECTOR IDENTIFICATION . If an intermittent condition exists, see INTERMITTENT CONDITIONS under SELF-DIAGNOSTIC SYSTEM. If testing requires component removal or replacement, see appropriate REMOVAL & INSTALLATION article. If diagnosis requires testing of sensor operating range, see appropriate table in SENSOR OPERATING RANGE CHARTS - CARS
article.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.