Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Conditions For Running
2004 Oldsmobile Bravada RWDSECTION Conditions For Running
WARNING: This page is about a different car, the 2003 Cadillac Seville and 2003 Cadillac DeVille. However, it is still accessible from the selected car via links, so may be relevant.
Passive Test
- The start-up Engine Coolant Temperature (ECT) is 41-176°F (5-80°C).
- The ECT is 41-226°F (5-108°C).
- The Intake Air Temperature (IAT) is 41-162°F (5-72°C).
- The Mass Airflow (MAF) is less than 35 g/s.
- The air/fuel ratio is more than 12.1:1
- The Manifold Absolute Pressure (MAP) is more than 50 kPa.
- The battery voltage is more than 10.2 volts.
Active Test
- Failed or inconclusive passive test.
- The engine load is less than 80 percent.
- The engine speed is more than 1000 RPM.
- The engine is operating in Closed Loop fuel control.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.