Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Procedures For Selecting Crank Position Sensing Decode Mode
When diagnosing the CKP sensors, it may be necessary to enable a specific decode mode (Angle, Time A or Time B). To enable a specific crank decode, using the scan tool, perform the following steps:
- Turn ignition on, with engine off.
- Select ENGINE OUTPUT CONTROLS.
- Select CRANK POSITION SENSING DECODE MODE.
- Select the desired mode (ANGLE, TIME A, or TIME B) by pressing SELECT STATE.
- Command the decode mode by pressing COMMAND STATE.
The commanded state remains valid for the current ignition cycle. A specific decode mode can not be commanded with the engine running, or after commanding a desired decode mode. To command a different decode mode, you must cycle the ignition off and on.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.