Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Conditions For Running DTC
2004 Oldsmobile Bravada RWDSECTION Conditions For Running DTC
WARNING: This page is about a different car, the 2003 Cadillac Seville and 2003 Cadillac DeVille. However, it is still accessible from the selected car via links, so may be relevant.
- DTCs P0102, P0103, P0106, P0107, P0108, P0121, P0122, P0123, P0401, P0404, P0405, P0440, P0442, P0446, P1404 or P1441 are not set.
- The engine is running.
- The ignition 1 signal is 11-18 volts.
- The MAP sensor is less than 59 kPa.
- The change in the MAP sensor is less than 4 kPa.
- The Throttle Position (TP) sensor angle is less than 48 percent.
- The change in the TP sensor angle is less than 3 percent.
- The Exhaust Gas Recirculation (EGR) position sensor is less than 90 percent.
- The Evaporative Emission (EVAP) canister purge valve command is less than 90 percent.
- The traction control is inactive (if equipped).
- The conditions are met for 10 seconds.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.