Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA RWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 386 (ENGINE CONTROLS - REMOVAL & INSTALLATION)TORQUE SPECIFICATIONS
2004 Oldsmobile Bravada RWD
Torque Specifications
2004 Oldsmobile Bravada RWDSECTION Torque Specifications
WARNING: This page is about a different car, the 2003 Pontiac Aztek and 2003 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
TORQUE SPECIFICATIONS
| Application | Ft. Lbs. (N.m) | |||||||
|---|---|---|---|---|---|---|---|---|
| Catalytic Converter Nuts | 25 (34) | |||||||
| Crankshaft Balancer Bolt | (1) 52 (70) | |||||||
| EGR Valve Bolt | 22 (30) | |||||||
| EGR Valve Pipe Bolt/Nut | 18 (25) | |||||||
| Engine Coolant Temperature Sensor | 15 (20) | |||||||
| Engine Mount Strut Bolt/Nut | 35 (48) | |||||||
| Frame Bolts | ||||||||
| Front Bolts | 114 (155) | |||||||
| Rear Bolts | 177 (240) | |||||||
| Fuel Feed Pipe Nut At Fuel Rail | 13 (17) | |||||||
| Fuel Filler Pipe Attaching Nut/Screw | 18 (25) | |||||||
| Fuel Return Pipe Nut At Pressure Regulator | 13 (17) | |||||||
| Fuel Tank Strap Bolts | 35 (47) | |||||||
| Heated Oxygen Sensor | 30 (41) | |||||||
| Knock Sensor | 14 (19) | |||||||
| Power Steering Mounting Bolts | 25 (34) | |||||||
| Spark Plug | (2) | |||||||
| Throttle Body Bolts/Nuts | 21 (28) | |||||||
| Wheel Lug Nuts | 100 (140) | |||||||
| INCH Lbs. (N.m) | ||||||||
| Accelerator Control Cable Bracket (3) | ||||||||
| Bolt | 115 (13.0) | |||||||
| Nut | 89 (10.0) | |||||||
| Accelerator Controls Pedal Bolts/Nuts | 27 (3.0) | |||||||
| Air Cleaner Housing Assembly Bolts | 89 (10.0) | |||||||
| Air Cleaner Intake Duct Clamps | 18 (2.0) | |||||||
| Camshaft Position Sensor | 71 (8.0) | |||||||
| Crankshaft Position Sensor "A" (24X) | 89 (10.0) | |||||||
| Crankshaft Position Sensor "B" (7X) | 97 (11) | |||||||
| EVAP Canister Purge Solenoid Bolt | 89 (10.0) | |||||||
| EVAP Canister Retaining Nut | 89 (10.0) | |||||||
| Front Fender Diagonal Brace-To-Inner Fender Bolts | 89 (10.0) | |||||||
| Front Fender Diagonal Brace-To-Radiator Support Bolts | 89 (10.0) | |||||||
| Fuel Filler Pipe Hose Clamp | 22 (2.5) | |||||||
| Fuel Pressure Regulator Screw | 76 (8.5) | |||||||
| Fuel Rail Bolt | 89 (10.0) | |||||||
| Fuel Sender Shield Nuts | 53 (6.0) | |||||||
| Idle Air Control Valve | 27 (3.0) | |||||||
| Ignition Control Module Mounting Screw | 40 (4.5) | |||||||
| Ignition Coil Mounting Screw | 40 (4.5) | |||||||
| Manifold Absolute Pressure Sensor Screws | 27 (3.0) | |||||||
| PCM Connector Screw | 71 (8.0) | |||||||
| Throttle Position Sensor Bolts | 18 (2.0) | |||||||
| Transaxle Fluid Filler Tube Bolt/Nut | 115 (13.0) | |||||||
|
||||||||
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.