Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Accelerator Controls Cable Bracket: Removal
2004 Oldsmobile Bravada RWDSECTION Removal
WARNING: This page is about a different car, the 2003 Pontiac Aztek and 2003 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
- Disconnect the accelerator controls cable cross slug from the throttle body lever. See Figure . Disconnect the accelerator controls cable from the accelerator cable bracket. Disconnect the cruise control cable from the throttle lever and accelerator bracket, if applicable. See Figure .
- Disconnect the air cleaner intake duct from the throttle body. See AIR CLEANER INTAKE DUCT under AIR INDUCTION SYSTEMS. Disconnect the wire harness from the retainer. Remove the nut and bolts holding the accelerator cable bracket to the throttle body. Remove the accelerator cable bracket.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.