SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA RWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 382 (ENGINE CONTROLS - REMOVAL & INSTALLATION)MISCELLANEOUSACCELERATOR CONTROLS PEDALINSTALLATION
2004 Oldsmobile Bravada RWD

Accelerator Controls Pedal: Installation

2004 Oldsmobile Bravada RWDSECTION Installation
WARNING: This page is about a different car, the 2003 GMC Safari and 2003 Chevrolet Astro. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: The accelerator cable is not to be kinked or damaged in any way during installation. Ensure that the mounting surface between the accelerator pedal assembly and the dash panel is free of insulation. The carpet and padding in the pedal area must be positioned to lay flat and be free of wrinkles and bunches. Wire, hoses, cables, and other flexible components should not be within 0.52" (13 mm) of the cable or lever, at any point in their travel. The pedal must operate freely without binding through the full range of pedal movement.

Place the accelerator pedal assembly on the mounting surface. Install the three mounting bolts. Tighten mounting bolts to specification. See TORQUE SPECIFICATIONS  . Lift upward on the accelerator pedal. Insert the cable through the pedal lever slot. Press the retainer into the lever hole until fully seated. Check the pedal for free movement by pressing down on the pedal.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.