Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA RWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 382 (ENGINE CONTROLS - REMOVAL & INSTALLATION)IGNITION SYSTEMSDISTRIBUTORREMOVAL
2004 Oldsmobile Bravada RWD
Ignition Systems: Distributor: Removal
2004 Oldsmobile Bravada RWDSECTION Removal
WARNING: This page is about a different car, the 2003 GMC Safari and 2003 Chevrolet Astro. However, it is still accessible from the selected car via links, so may be relevant.
- Turn ignition off. Disconnect negative battery cable. Remove engine cover. See ENGINE COVER under MISCELLANEOUS. Remove air cleaner assembly. See AIR CLEANER ASSEMBLY under AIR INDUCTION. Remove air intake resonator assembly.
- Reference mark spark plug wires at distributor cap for reassembly. Slightly twist all spark plug wires and ignition coil wire at distributor cap. Remove all spark plug wires and ignition coil wire at distributor cap by pulling on the wire boot.
- Disconnect harness connector at base of distributor. Remove distributor cap retaining screws and distributor cap. See Fig 1 . Using a grease pencil, mark position of the distributor rotor in relation to the distributor housing. Make another mark on the intake manifold in relation to the mark made on the distributor housing.
- Remove distributor hold-down bolt. Lift distributor upward while observing counterclockwise rotation of distributor rotor. Once distributor is fully removed, place a second reference mark on the distributor housing in relation to the distributor rotor position. See Figure .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.