SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA RWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 382 (ENGINE CONTROLS - REMOVAL & INSTALLATION)FUEL SYSTEMSFUEL LEVEL SENSORREMOVAL & INSTALLATION
2004 Oldsmobile Bravada RWD

Removal & Installation

2004 Oldsmobile Bravada RWDSECTION Removal & Installation
WARNING: This page is about a different car, the 2003 GMC Safari and 2003 Chevrolet Astro. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Numbers in parentheses refer to numbers in illustration.

Remove the fuel sender assembly. See FUEL SENDER ASSEMBLY  . Disconnect the fuel pump electrical connector (5). See Fig 1 . Remove the fuel level sensor electrical connector retaining clip (6). Disconnect the fuel level sensor electrical connector (7) from under the fuel sender cover. Remove the fuel level sensor retaining clip (4). Squeeze the locking tangs and remove the fuel level sensor (3). To install, reverse removal procedure. Check for fuel leaks.

Fig 1: Identifying Fuel Sender Assembly Components
G00217038Courtesy of GENERAL MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.