SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE2004BRAVADA RWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 379 (ENGINE CONTROLS SELF-DIAGNOSTICS)PROGRAMMINGTHEFT DETERRENT PASSWORD LEARN PROCEDURE30-MINUTE LEARN PROCEDURE
2004 Oldsmobile Bravada RWD

30-Minute Learn Procedure

2004 Oldsmobile Bravada RWDSECTION 30-Minute Learn Procedure
WARNING: This page is about a different car, the 2003 Pontiac Aztek and 2003 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.

Use this procedure after replacing the following components:

  • PassKey® III (PK3) keys.
  • Theft deterrent control module.
  • PCM.

NOTE: This procedure is not available on vehicles equipped with option code (Z49 or BAE).

If replacing a theft deterrent control module with an GM SPO Replacement Part, perform the procedure to setup a new theft deterrent control module prior to the 30-minute relearn procedure.

  1. With a master PassKey® III key (Black), Turn ignition on, with engine off.
  2. Observe the Security telltale, after about 10 minutes, the telltale will turn off.
  3. Turn ignition off and wait 5 seconds.
  4. Repeat steps  1- 3 for 2 more times, for a total of 3 cycles or 30 minutes.
    5. NOTE: The vehicle learns the key transponder information and/or passwords on the ignition switch transition from OFF to CRANK. You must turn the ignition OFF before attempting to start the engine.
  5. With a master PassKey® III key, start engine. The vehicle has now learned the key transponder information and the PCM has now learned the fuel continue password.
  6. With a scan tool, clear any DTCs.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.